SYNTECH ROADWARE

Two-component urethane in cartridge for quick repairs of concrete

Code: SYN.0327

Components: 1

Appearance: Liquid

SYNTECH ROADWARE is a high penetration two-component hybrid urethane which, combined with quartz, produces a hard and instant polymer to repair cracks and crevices in concrete floors.

Certification obtained and Standards

Product of the Floor line, the line of products from Azichem Srl dedicated to the main, complementary products and accessories for the construction, restoration and/or renovation of concrete floors and screeds.

Floor - Prodotti per pavimenti e massetti in calcestruzzo

Product of the Floor line, the line of products from Azichem Srl dedicated to the main, complementary products and accessories for the construction, restoration and/or renovation of concrete floors and screeds.

General characteristics

pot-life

Pot-life: 10 min

adhesion-to-the-substrate

Adhesion to the substrate: 13.7 MPa

mixing-ratio

Mixing ratio: 1:1 _

use-wearing-protective-gloves

Use wearing protective gloves

Technical specifications

Breaking load longitudinal

30 MPa

Longitudinal elongation at break

6 %

VOC content

5.5 g/l

Hardness

72D _

Viscosity

< 9 mPas

Available colours

- Dark gray

Packaging and dimensions

- Bi-mix cartridge 600 ml

Characteristics

SYNTECH ROADWARE has a very low viscosity allowing the penetration of the product in depth, even in the narrowest cracks. It has short reaction times, in fact in 10 minutes at 20°C the material polymerizes completely and catalyzes quickly even in environments with temperatures below 0°C. It has good resistance to chemical attack. When combined with quartz powder, SYNTECH ROADWARE, forms a highly resistant compound with properties similar to existing concrete but with the flexibility that persists over time.

Consumption

With a SYNTECH ROADWARE cartridge, an average of 50 linear metres of gap of 5 mm width is repaired.

Use fields

Repair of splits or cracks in concrete, restoration of deteriorated concrete degradation, repair of cracks and pop-out phenomena in concrete.

Preparation of supports

Slightly widen the crack with a circular saw to facilitate the penetration of SYNTECH ROADWARE. Before applying the product, vacuum the dust created. The support must be clean and free from dust or dirt.

Use method

Apply SYNTECH ROADWARE directly on the crack or on the degraded area until the gap is completely saturated. Add quartz directly to the crack and repeat the SYNTECH ROADWARE application operation. Smooth with a spatula and leave the product to work.

Application methods

- Dispensing gun

Tool cleaning

- Nitro thinner

Permitted supports

- Concrete

Share

Products on display

  • Syntech Poliurea
  • Syntech H.A.G.
  • Protech Balcony