SYNTECH PAVISHEER

Epoxy treatment for transparent coatings

Code: SYN.0106

Components: 2

Appearance: Liquid

Two-component transparent epoxy system, based on epoxy and amino-resins in aqueous dispersion, free from solvents, characterised by a high content of solids that provides, after application and curing, a coating with good mechanical resistance and chemical, especially related to contact with oils and solvents.

Certification obtained and Standards

Product of the Floor line, the line of products from Azichem Srl dedicated to the main, complementary products and accessories for the construction, restoration and/or renovation of concrete floors and screeds.

Floor - Prodotti per pavimenti e massetti in calcestruzzo

Product of the Floor line, the line of products from Azichem Srl dedicated to the main, complementary products and accessories for the construction, restoration and/or renovation of concrete floors and screeds.

General characteristics

shelf-life

Shelf-life: 12 months

temperature-of-use

Temperature of use: +10 / +30 °C

solvent-free

Solvent-free

mixing-ratio

Mixing ratio: 100:67 _

pot-life

Pot-life: 80-105 min

nonflammable

Nonflammable

use-wearing-protective-gloves

Use wearing protective gloves

density

Density: 1.05 (±0.05) kg/dm³

Technical specifications

Viscosity

16000 ±3200 mPa

Complete hardening

7 day

Hard to touch

4-6 h

Dry residue

68 %

Available colours

- Transparent

Packaging and dimensions

- Can 3 kg [A]

- Can 2 kg [B]

- Kit: 1 Can 3 kg [A] + 1 Can 2 kg [B]

- Can 15 kg [A]

- Can 10 kg [B]

- Kit: 1 Can 15 kg [A] + 1 Can 10 kg [B]

Consumption

From 0.20 to 0.40 kg of SYNTYECH PAVISHEER for each square metre of surface to be covered.

Use fields

Transparent finish of interior floor coverings, mechanical-resistant impregnations, anti-dust and anti-oil for concrete surfaces.

Preparation of supports

The media should have adequate mechanical resistance. The concrete surfaces should be cured, dry, planar and absorbent, free from oils, detergents, powders and soiling. The most appropriate type of mechanical preparation should also be determined (degreasing or shot peening).

Conveniently absorbent surfaces may be dealt with directly after a proper cleaning. For tiled surfaces and for pre-existing coverings in resin, a degreasing or shot peening treatment is required until complete opacification and complete elimination of dust.

Use method

At the time of the application pour the two components into a single container and mix thoroughly for 2 minutes, with appropriate equipment (drill with helix). At the end of the mixing stage, resting and application times must be scrupulously respected, as described in the table reported below.

SYNTECH PAVISHEER, must be diluted with 50% clean water. In this case, the consumption of the mixture in aqueous solution will be around 150-200 g/m² (one coat).

Application methods

- Brush

- Paint roller

Tool cleaning

- Water

Permitted supports

- Concrete

- Prefabricated concrete

- Tiles

- Floor screed

- Rock walls

Warnings, precautions and Ecology

If the times of induction and use are not respected, the finish may be subject to deformities, highlighted by a non-constant "gloss" (degree of gloss). As it is, the product can be characterised by a high content of solids, the viscosity can be adapted to the desired level by the dilution with water.

Share

Products on display

  • Sanawarme
  • Osmocem
  • Syntech H.A.G.