Pure epoxy adhesive, two-component, low-viscosity, without loads and solvents, specifically for structural reinforcement, high-performance injections in dilapidated masonry, degraded concrete, dilapidated industrial screeds and flooring, cracked plasters and mortars, etc. Perfect for fixing bars, clamps and ties. Also specific for the in-depth reinforcement of wooden materials and other types of porous materials by impregnation with brush or roller.
Floor - Prodotti per pavimenti e massetti in calcestruzzo
Product of the Floor line, the line of products from Azichem Srl dedicated to the main, complementary products and accessories for the construction, restoration and/or renovation of concrete floors and screeds.
Shelf-life: 12 months
Pot-life: 25 min
Adhesion to the substrate: ≥3 N/mm²
Density: 1.08 kg/dm³
Use wearing protective gloves
Temperature of use: +5 / +30 °C
Ratio of catalysis
A : B = 100 : 50 %
Longitudinal elongation at break
Hard to touch
Reinforcing and filling injections of cracks in concrete, stone, brick, mixed works etc. Anchor, bonding and attachment of connectors, plates etc. Structural reinforcement and small volume rebuilding (only horizontal) in general. Reinforcement of porous construction materials such as wood, natural stone, bricks etc.
The surfaces of application will be seasoned and dry (residual humidity measured at a depth of 4 cm, should not be greater than 8 % ), free from dust, grease, soiling, crumbling and non-adhering parts.
Add component B to component A taking care to remove all the material from the packaging, mix thoroughly with a mixer at a low number of revolutions, until a perfectly homogeneous mixture is obtained; add the required load amount (component C) continue to mix until a perfectly homogeneous lump-free mixture is obtained. Lay the material using the techniques specific to the type of intervention: injection, pouring, brushing, etc..
- Pour out
- Paint roller
- Thinner for resins
- Cement-based or lime-based mortars
- Prefabricated concrete
- Mixed walls (bricks and stones)
- Stone walls
- Floor screed
- Rock walls
Do not apply on wet or pulverised media. Non-conformities of the support can have unpleasant drawbacks: detachments, large bubbles, etc. Apply only in the intended thermal intervention (+5/+30°C).
Use the product immediately after mixing and mix only the amount of product intended for immediate use.
SYNTECH IC 55 is a product based on fluid epoxy resins. It may cause variations in the colour of the product on which it is applied, both wood and stone material. For this reason it is recommended to carry out preliminary tests.
It is a classic, epoxy loaded mix, for the grouting of connectors in beams and wooden structures in general, before creating foundations, grouts and plaster.
Three-component, epoxy liquid mortar, specifically for the reconstruction of beam heads in worn wood and deteriorated portions, to repair by casting.
SYNTECH AS 31
Loaded epoxy, two-component thixotropic mortar usable for precise repair of modest portions of works in deteriorated wood by applying with a trowel or spatula.