Appearance: Powder + Liquid
Two-component cement surfacer, fine, fluid plastic consistency, for plugging gaps between tiles, and to fill and joint static cracks, micro- and macro-cavities etc., prior to applying PROTECH BALCONY in non-pellicular transparent waterproofing interventions of terraces and balconies.
Max. recommended thickness: 6 mm
Maximum diameter of aggregate: 0.35 mm
Pot-life: 15 - 20 min
Shelf-life: 12 months
Temperature of use: +5 / +35 °C
Use wearing protective gloves
Mixing ratio of the components
- Light gray
- Pail 4 kg [A]
- Bottle 1 kg [B]
- Kit: 1 Pail 4 kg [A] + 1 Bottle 1 kg [B]
- Bucket 0.8 kg [A]
- Bucket 0.2 kg [B]
- Kit: 1 Bucket 0.8 kg [A] + 1 Bucket 0.2 kg [B]
Approximately 1.75 kg of STUCCO BALCONY for each cubic decimetre of volume to be grouted.
Specific putty for the preliminary preparation of supports (open gaps, micro and macro-cavities and fissures) for the subsequent application of PROTECH BALCONY on terraces and balconies.
Application surfaces should be clean, free of soiling, crumbling and non-adhering parts, dust, etc., conveniently saturated with water until they reach the condition "saturated with dry surface".
Add the quantity of component B required to obtain the desired consistency to component A; mix thoroughly until a homogeneous lump-free mixture is obtained. Place on site using a spatula, sponge float or simply with the fingers of the hand (wearing a rubber glove).
it is possible to correct the consistency, where necessary, by adding moderate quantities of water to the ready mixture.
In the cases of coloured surfacings, it is recommended to mix the two-component with small amounts of coloured pigments that can be purchased at any paint shop.
- Apply by hand
- Sponge float
Do not apply in case of direct exposure to sunlight. Cure the prolonged moist hardening of exposed surfaces.
Given the high adherence and rapid drying of the product, it is advisable to wash the excess parts of the surfacings immediately after application, with a sponge impregnated with water, ("smudges") to avoid tedious cleaning
In transparent non-pellicular waterproofing interventions of terraces and balconies, STUCCO BALCONY must only be applied to restore the continuity of labile, detached or missing puttying. For this reason, the consumption is extremely variable from case to case, depending on the actual volume of filling to be performed.
PROTECH BALCONY is a ready to use concentrated single-component solution, made out of silicone-based resins and organic polymers catalysed in solvent. The solution viscosity is lower than that of water, so as to penetrate any cracks liable for water
Products and accessories for adequately deformable cement osmotic waterproofing, thanks to special, flexibilising agents with a rubber base, particularly indicated for tiled terraces and balconies.
Vuoi saperne di più sui nostri prodotti?