Powdered compound to prepare, with the sole addition of water, a rheoplastic, castable, slightly expansive, shrinkage-compensated micro-cement mortar micro-cement mortar, high performance in terms of adherence and mechanical performance.
Floor - Prodotti per pavimenti e massetti in calcestruzzo
Pot-life: 60 min
Shelf-life: 12 months
Temperature of use: +5/+35 °C
Maximum diameter of aggregate: 0.35 mm
Filling the joints (vanishing points) in urban floorings in porphyry, stone slabs etc., in new installations and in the reinforcement of existing installations. Anchorages and rigid seals in general.
Remove the soilings, the crumbling and non-adhering parts and saturate beforehand with water.
Pour about 2/3 of the required mixture water in the mixer (about 3.5 -4 litres total per bag); gradually add the product and the water still required to get the desired consistency. Continue mixing until you obtain a homogeneous, lump-free mortar. Pour the compound thus obtained in the vanishing points to be filled.
- Pour out
- Floor screed
- Porphyry and natural stones
Do not apply in the presence of stagnant water and direct solar irradiation, in anticipation of atmospheric precipitation and/or sudden drops in temperature.
Treat the hardening and the damp protection fresh mortar placed on site .
Power additive to create reinforced grout, injectable, to add to cement or hydraulic lime.
Cement grout (binary mix without aggregates), slightly expansive, ready for injection with low pressure or dropped into walls, with the sole addition of water. You are advised to use in walls built before 1900.
Micro-cement mortar, injectable, slightly expansive, for wall reinforcement and cavity filling, to use in grout solutions if the cavities are big or if high performance must be achieved.
Hydraulic lime based grout (binary mix without aggregates), slightly expansive, ready for injection with low pressure in walls, with the sole addition of water. Perfect for monument restorations of historic works.