Superfluid, injectable, ultra-high flowability and stability cement grout, moderately expansive in the plastic phase, for fixings, anchorages, wall reinforcements, fillings, post-tensioning sheathing fills etc., based on high-resistance cements, specific agents, superpozzolanic reactive fillers. EXEMPT FROM AGGREGATES.
Products and systems for the protection and repair of concrete structures - Anchoring of reinforcing steel bar
Masonry mortars - Masonry mortar for general purposes (G)
Floor - Prodotti per pavimenti e massetti in calcestruzzo
Product of the Floor line, the line of products from Azichem Srl dedicated to the main, complementary products and accessories for the construction, restoration and/or renovation of concrete floors and screeds.
Shelf-life: 12 months
Temperature of use: +5/+35 °C
Pot-life: 30-45 min
Mix with water: 33 - 35 %
No bleeding according to UNI 8998
Compressive strength after 07 days
> 55 N/mm²
Compressive strength after 01 day
> 15 N/mm²
Compressive strength after 28 days
> 65 N/mm²
> 3 N/mm²
Flexural strength after 28 days
> 9.5 N/mm²
Flexural strength after 07 days
> 8.0 N/mm²
Flexural strength at 01 day
> 4.5 N/mm²
- Bag 25 kg
- Pallet: 50 x (Bag 25 kg)
The mixing water requirement of GROUT CABLE, extremely reduced, is close to the permanently, chemically and physically set quantity, from the cement (stoichiometric water); there ensue exceptional characteristics in terms of stability and performance that are further increased by a peculiar anti-shrinkage action in the plastic phase and from the superpozzolanic reactivity that distinguishes the product.
Approximately 1700 kg of GROUT CABLE for each cubic metre of volume to be filled.
Reinforcing and anchoring injections in galleries, hydraulic, industrial, marine, underground works; filling of containment sheaths, post-tensioned cable structures, padding, fissured concrete or mixed masonry works.
Pour about 2/3 of the mixing water into the mixer, gradually add GROUT CABLE and the remaining water until a fluid and homogeneous mixture is obtained. Reinforcing backfills and fills can be carried out both by gravity and using manual or automatic pumps, depending on the type of application.
- Pour out
- Prefabricated concrete
- Mixed walls (bricks and stones)
- Stone walls
It is not advisable to use the product for reinforcing injections of vintage masonry made before 1900, since the risk of undesirable reactions with some internal masonry components (gypsum minerals) would cause the formation of "ettringite" and "thaumasite ", deleterious for reinforcement as they are strongly expansive. In these cases, use SANAFLUENS or FLUID CABLE added to hydraulic lime as an alternative.
Power additive to create reinforced grout, injectable, to add to cement or hydraulic lime.
Micro-cement mortar, injectable, slightly expansive, for wall reinforcement and cavity filling, to use in grout solutions if the cavities are big or if high performance must be achieved.
Hydraulic lime based grout (binary mix without aggregates), slightly expansive, ready for injection with low pressure in walls, with the sole addition of water. Perfect for monument restorations of historic works.
Product similar to GROUT MICRO-J, specifically for sealing joints between block paving and natural stone flooring in general.