SYNTECH POLIUREA is a liquid, two-component and elastic membrane in pure, hot vaporised polyurea with the highest performance, for continuous polymer coating and waterproofing of a wide range of supports.
SYNTECH POLIUREA PRIMER
Two-component epoxy primer for polyurea, suitable for all surfaces
SYNTECH POLIUREA SPRAY
Ultra flexible waterproofing elastomeric (polyurea) membrane
SYNTECH POLIUREA TOP COATING
Aliphatic polyurethane resin-based protective coating
SYNTECH POLIUREA is a two-component resin forming part of the continuous waterproofing range with Polyurethane Elastomers”. The polymerisation reaction is similar to that leading to the formation of polyurethanes. Obtained through polyaddition of an aliphatic or aromatic diisocyanate with a diamine, it is structurally characterised by the repetition of a RNH(CO)NHR' unit, basically a molecule of disubstituted urea.
POLYUREA, in general, has been used for over twenty years on the international market, for waterproofing, flooring, the protection of concrete, metal surfaces, fibreglass surfaces, containers for foodstuffs and drinking water, the protection and encapsulating of asbestos cement, for coatings in general in tanks and various containers, for its exceptional chemical, physical, mechanical and performance properties.
Characterised by very high application flexibility (from 400 to 600%), SYNTECH POLIUREA is a product that immediately forms a reticular structure (310’’), even at low temperatures (up to 15°C) and is available in two different formulations: SYNTECH POLIUREA SPRAY 400 (applicable on almost all types of supports) and SYNTECH POLIUREA SPRAY SPUR (specifically to restore waterproofing of old bituminous sheaths), both of an Aromatic nature. SYNTECH POLIUREA is applied as a spray with a thickness of no less than 2 mm (minimum consumption: 2.1 kg/m²) with particular airless bimixer, high pressure pumps (approx. 210 bar) that vaporise the hot product (approx. 70°C) on a wide range of materials (concrete, old bituminous sheaths, fine porcelain stoneware, ceramic, terracotta, tiles in reconstructed stone, wood, iron, sheet metal, polystyrene, polyurethane, etc..), also with complex geometries, on appropriate preparation of the support and laying of the specific primer SYNTECH POLIUREA PRIMER (for applications on metal surfaces, the special formulation SYNTECH POLIUREA PRIMERMETAL is used).
The peculiar performance and resulting advantages of the coatings with a SYNTECH POLIUREA base ensure the ideal system for waterproofing, coating and protection of various types of structures, buildings and waterworks: Garages and multi-storey car parks; perimeter roofs; roof garden; roofs with photovoltaic systems; swimming pools; maintenance and renovation of old bituminous sheaths; waterproofing with demolishing terraces, walkways and balconies; perimeter walls in concrete underground with positive thrust; decks, bridges and viaducts, roads and rail; dams, canals and waterworks in general; buffering of cracked prefabricated works, coatings insulated with expanse polyurethane or thermo-insulating panels.
SANATIGH: dehumidifying renewal of damp walls
INDUSTRIAL FLOORING with high performance, fibre-reinforced concrete
CONSILEX ANTIMUFFA: definitively eliminates mould from walls
Repair of concrete structures in marine environments
PRERIT: set retarder for
'REPAR' products: structural renovation with shrink-proof, thixotropic mortar
FLOOR Q: cortical repair of fine concrete floors
'GROUT' products: reconstruction of block concrete with poured casts
WATERPROOF CONCRETE: special products for underground structures with hydraulic seal.
SYNTECH HAG: infiltration stoppage with hydro-reactive resins