GROUT CABLE

Superfluid, reinforcing, injectable cement grout

Codice: GRT.0073

Componenti: 1

Aspetto: Powder

Superfluid, injectable, ultra-high flowability and stability cement grout, moderately expansive in the plastic phase, for fixings, anchorages, wall reinforcements, fillings, post-tensioning sheathing fills etc., based on high-resistance cements, specific agents, superpozzolanic reactive fillers. EXEMPT FROM AGGREGATES.

Certificazioni ottenute e Normative

Masonry mortars - Masonry mortar for general purposes (G)

EN 998-2

Masonry mortars - Masonry mortar for general purposes (G)

Floor - Prodotti per pavimenti e massetti in calcestruzzo

Caratteristiche generali

shelf-life

Shelf-life: 12 months

temperature-of-use

Temperature of use: +5/+35 °C

solvent-free

Solvent-free

pot-life

Pot-life: 30-45 min

nonflammable

Nonflammable

uv-resistant

UV-resistant

mix-with-water

Mix with water: 28-30 %

Specifiche tecniche

Darcy impermeability

10^(-10) cm/s

pH

>12 _

Water/binder ratio

0.3 _

Compressive strength

> 50 N/mm²

No bleeding according to UNI 8998

Flexural strength

> 7 N/mm²

Colori disponibili

- Gray

Caratteristiche

The mixing water requirement of GROUT CABLE, extremely reduced, is close to the permanently, chemically and physically set quantity, from the cement (stoichiometric water); there ensue exceptional characteristics in terms of stability and performance that are further increased by a peculiar anti-shrinkage action in the plastic phase and from the superpozzolanic reactivity that distinguishes the product.

Campi d'impiego

Reinforcing and anchoring injections in galleries, hydraulic, industrial, marine, underground works; filling of containment sheaths, post-tensioned cable structures, padding, fissured concrete or mixed masonry works.

Modalità d'impiego

Pour about 2/3 of the mixing water into the mixer, gradually add GROUT CABLE and the remaining water until a fluid and homogeneous mixture is obtained. Reinforcing backfills and fills can be carried out both by gravity and using manual or automatic pumps, depending on the type of application.

Metodi di applicazione

- Pour out

- Injection

Pulizia strumenti

- Water

Supporti consentiti

- Concrete

- Prefabricated concrete

- Mixed walls (bricks and stones)

- Stone walls

Avvertenze, precauzioni ed Ecologia

It is not advisable to use the product for reinforcing injections of vintage masonry made before 1900, since the risk of undesirable reactions with some internal masonry components (gypsum minerals) would cause the formation of "ettringite" and "thaumasite ", deleterious for reinforcement as they are strongly expansive. In these cases, use SANAFLUENS or FLUID CABLE added to hydraulic lime as an alternative.

Condividi